Urecon?s Factory Insulated Pipe Duct System

Advantages of Urecon's insulated duct system:

• Very lightweight (approximately 4.5 kg (10 lbs) per length).

• Incorporates Urecon's eco-friendly U.I.P.? polyurethane foam, which is the best insulation available in the market today; refer to the product submittal data sheet or specifications for more details.

• UV stable polyethylene jacket is both tough and waterproof over the long term; this is critical for maintaining maximum efficiency of insulation. Flimsy thin jackets usually don't stand up to the wear and tear of transport, let alone long term underground performance. Wet or damp insulation of any type simply does not work.

• The insulation has a constant outside diameter down the entire pipe, including over the bell end. The insulation and jacket are factory trimmed flush with the bell end, allowing for the insulation to butt up against itself as the pipes and / or fittings are being solvent welded and pushed together.

• Butyl mastic sealant tape is supplied for all pipe and fitting ends to seal the system against water ingress.

• 45? and 90? solvent weld PVC short or long sweep factory insulated elbows are available for building entries and changes of direction.

• An insulated duct system gives you the flexibility to use whatever core pipe you think is best suited for your application, preferably pulled through the duct in continuous runs with no unions. The duct also allows you to run other utilities in the same raceway (local codes and bylaws permitting) i.e. telephone, cable, high speed internet, power, etc.